Need additional outputs for your MCM-100 Midi to CV module? The MCM-100-EX expansion module adds an additional four fully assignable CV outputs.
This 2hp wide module makes it easy to plug in and get going. With the power turned off to your MCM-100, just attach the included cable, power on, and configure the route settings for your additional four outputs. Just like with the standard two assignable CV outputs on the MCM-100, the four outputs on the MCM-100-EX can be assigned to output any of the recevied MIDI events below. Each output is also configurable to output at a maximum of +10 volts or +5 volts for any CV voltage (+5 volts for signal and pulse events such as clock ticks).
- Note on / off:
- For +10v output, responds to C-1 (note number 0) to B9 (note number 119).
- For +5v output, responds to C2 (middle-C, note number 36) to B6 (note number 95).
- Volume / velocity
- Clock tick: MIDI clock ticks are sent directly to the
Clockoutput and can be routed to any of the assignable CV output as well. The clock ticks are configurable to pulse with every tick, or every 2, 4, 6, 8, 12, 24, 36, 48, 60, 72, or 96 ticks. - Aftertouch
- Expression
- Mod wheel
- Effect 1
- Effect 2
- Start and Continue sequence
- Stop sequence
Comes with the MCM-100-EX module, mounting screws, and a 10p connecting cable to attach to your MCM-100 module.
Note: To use the MCM-100-EX Expansion Module, you must have the MCM-100 Midi to CV Module. The MCM-100-EX will not work on its own.
